<?xml version="1.0" encoding="UTF-8"?><rss version="2.0"
	xmlns:content="http://purl.org/rss/1.0/modules/content/"
	xmlns:dc="http://purl.org/dc/elements/1.1/"
	xmlns:atom="http://www.w3.org/2005/Atom"
	xmlns:sy="http://purl.org/rss/1.0/modules/syndication/"
		>
<channel>
	<title>Comments on: How can I replace broken screen in HP Pavilion dv8 notebook?</title>
	<atom:link href="http://www.asklaptopfreak.com/laptop-notebook-help/2010/05/08/replace-broken-screen-hp-pavilion-dv8-notebook/feed/" rel="self" type="application/rss+xml" />
	<link>http://www.asklaptopfreak.com/laptop-notebook-help/2010/05/08/replace-broken-screen-hp-pavilion-dv8-notebook/</link>
	<description>Your laptop computer doesn't work? Need help or support for your notebook? Ask the Laptop Freak!</description>
	<lastBuildDate>Mon, 30 Jan 2012 16:03:21 +0000</lastBuildDate>
	<sy:updatePeriod>hourly</sy:updatePeriod>
	<sy:updateFrequency>1</sy:updateFrequency>
	<generator>http://wordpress.org/?v=3.3.1</generator>
	<item>
		<title>By: Jeff</title>
		<link>http://www.asklaptopfreak.com/laptop-notebook-help/2010/05/08/replace-broken-screen-hp-pavilion-dv8-notebook/comment-page-1/#comment-300604</link>
		<dc:creator>Jeff</dc:creator>
		<pubDate>Sat, 29 Jan 2011 19:55:41 +0000</pubDate>
		<guid isPermaLink="false">http://www.asklaptopfreak.com/?p=498#comment-300604</guid>
		<description>The screens on a dv8, HDX models and I am sure there are others. Are very difficult to remove. HP had come up with this flush bezel design where the screens are held in place with this 3M industrial acrylic two sided tape. This tape is not meant to be removed. However, with a very hot hair drier and lots patience the screen can be carefully pried from the bezel. The next obstacle is to remove the old tape from the bezel with out damaging it. Lacquer thinner is required here. Do not over do it as the thinner will eventually remove the black paint on the inside of the bezel. Also, the front plastic cover is held in place on the bezel with he same tape, too much use of the thinner will weaken this bond and cause problems.
 The tape can be found at an auto supply store as it&#039;s also used to stick the molding on car doors. You can also buy a totally new screen assembly from HP for around 350.00 to 400.00 $. I found a severely scratched screen so I could practice this procedure and the most difficult part was removing the old adhesive from the bezel with out damaging it.
 Good luck with this.</description>
		<content:encoded><![CDATA[<p>The screens on a dv8, HDX models and I am sure there are others. Are very difficult to remove. HP had come up with this flush bezel design where the screens are held in place with this 3M industrial acrylic two sided tape. This tape is not meant to be removed. However, with a very hot hair drier and lots patience the screen can be carefully pried from the bezel. The next obstacle is to remove the old tape from the bezel with out damaging it. Lacquer thinner is required here. Do not over do it as the thinner will eventually remove the black paint on the inside of the bezel. Also, the front plastic cover is held in place on the bezel with he same tape, too much use of the thinner will weaken this bond and cause problems.<br />
 The tape can be found at an auto supply store as it&#8217;s also used to stick the molding on car doors. You can also buy a totally new screen assembly from HP for around 350.00 to 400.00 $. I found a severely scratched screen so I could practice this procedure and the most difficult part was removing the old adhesive from the bezel with out damaging it.<br />
 Good luck with this.</p>
]]></content:encoded>
	</item>
	<item>
		<title>By: carlos</title>
		<link>http://www.asklaptopfreak.com/laptop-notebook-help/2010/05/08/replace-broken-screen-hp-pavilion-dv8-notebook/comment-page-1/#comment-200187</link>
		<dc:creator>carlos</dc:creator>
		<pubDate>Fri, 06 Aug 2010 08:00:25 +0000</pubDate>
		<guid isPermaLink="false">http://www.asklaptopfreak.com/?p=498#comment-200187</guid>
		<description>My laptop fell down on the floor and asks for recovery, so it seems that it wont work if i dont do a recovery to it .. its ok for me to recover my laptop , but the recovery will erase all my files on my hard disk and i dont have a backup for them , what should i do ?</description>
		<content:encoded><![CDATA[<p>My laptop fell down on the floor and asks for recovery, so it seems that it wont work if i dont do a recovery to it .. its ok for me to recover my laptop , but the recovery will erase all my files on my hard disk and i dont have a backup for them , what should i do ?</p>
]]></content:encoded>
	</item>
	<item>
		<title>By: Taylor</title>
		<link>http://www.asklaptopfreak.com/laptop-notebook-help/2010/05/08/replace-broken-screen-hp-pavilion-dv8-notebook/comment-page-1/#comment-198373</link>
		<dc:creator>Taylor</dc:creator>
		<pubDate>Fri, 30 Jul 2010 22:49:16 +0000</pubDate>
		<guid isPermaLink="false">http://www.asklaptopfreak.com/?p=498#comment-198373</guid>
		<description>Hey :).
Recently, my laptop because faulty with the screen. Whenever I tilted the screen, it would become white + I would have to continue to tilt the screen till it went back to normal. Or, I could push a certain part of the screen. However, I seem to of pushed the screen, it which a black mark inside appeared with a crack in the middle. It runs down the side of the screen, however, only at the top is it back. When I turn the computer on, of works perfectly, the sounds etc, but the crack makes the screen unable to see anything. If I move the screen quickly, things appear for a split second. So do I have to buy a new laptop to resolve this?</description>
		<content:encoded><![CDATA[<p>Hey <img src='http://www.asklaptopfreak.com/wp-includes/images/smilies/icon_smile.gif' alt=':)' class='wp-smiley' /> .<br />
Recently, my laptop because faulty with the screen. Whenever I tilted the screen, it would become white + I would have to continue to tilt the screen till it went back to normal. Or, I could push a certain part of the screen. However, I seem to of pushed the screen, it which a black mark inside appeared with a crack in the middle. It runs down the side of the screen, however, only at the top is it back. When I turn the computer on, of works perfectly, the sounds etc, but the crack makes the screen unable to see anything. If I move the screen quickly, things appear for a split second. So do I have to buy a new laptop to resolve this?</p>
]]></content:encoded>
	</item>
	<item>
		<title>By: GP</title>
		<link>http://www.asklaptopfreak.com/laptop-notebook-help/2010/05/08/replace-broken-screen-hp-pavilion-dv8-notebook/comment-page-1/#comment-198346</link>
		<dc:creator>GP</dc:creator>
		<pubDate>Fri, 30 Jul 2010 20:48:37 +0000</pubDate>
		<guid isPermaLink="false">http://www.asklaptopfreak.com/?p=498#comment-198346</guid>
		<description>hi, just dropped my sony laptop. the screen seems intact but the keyboard part doesnt fix back in properly. The laptop is trying to boot and says there has been a problem but the screen has green and white lines in the centre and the rest of the screen is blank.....pls help.......have an exam soon and all my documents are on it.</description>
		<content:encoded><![CDATA[<p>hi, just dropped my sony laptop. the screen seems intact but the keyboard part doesnt fix back in properly. The laptop is trying to boot and says there has been a problem but the screen has green and white lines in the centre and the rest of the screen is blank&#8230;..pls help&#8230;&#8230;.have an exam soon and all my documents are on it.</p>
]]></content:encoded>
	</item>
	<item>
		<title>By: Maryellen</title>
		<link>http://www.asklaptopfreak.com/laptop-notebook-help/2010/05/08/replace-broken-screen-hp-pavilion-dv8-notebook/comment-page-1/#comment-182790</link>
		<dc:creator>Maryellen</dc:creator>
		<pubDate>Sun, 06 Jun 2010 20:27:17 +0000</pubDate>
		<guid isPermaLink="false">http://www.asklaptopfreak.com/?p=498#comment-182790</guid>
		<description>I do not have a shut off button on my screen.  how do I 

get it replaced?</description>
		<content:encoded><![CDATA[<p>I do not have a shut off button on my screen.  how do I </p>
<p>get it replaced?</p>
]]></content:encoded>
	</item>
</channel>
</rss>

